Mira Realm Installation, Operation, Maintenance Manual page 15

1.9. Temporarily fit the rigid riser pipe
and horizontal arm and wall bracket
to the shower control outlet and
mark the position of the wall bracket.
Use a spirit level to ensure the pipe
is vertical.
Note that the horizontal arm can be
shortened if required. De-burr the
pipe ends before making the final
connection.
1.10. Fix the wall bracket, rigid riser pipe
and hand-tighten the three
compression fittings on the shower
control outlet and horizontal arm.
Apply a further 3/4 to 1 1/4 turns to
each compression nut, with a
spanner, to effect a seal.
Note! Care must be taken when
tightening compression nuts so that
you do not damage the plated
surfaces.
1.11. Thoroughly flush the outlet pipework
before connecting the shower head.
Slide the compression nut over the
horizontal arm and make the
connection to the shower head.
15