Mira Realm Installation, Operation, Maintenance Manual page 14

Rigid Riser
Pipe
Compression
Nut
Olive
Grub
Screw
Shower
Control
Fixing
Screws
Olive
Horizontal
Arm
Compression
Nut
14
Wall Plug
Backplate
Concealing
Plate
Fixing
Screw
Wall Plugs
Rigid Riser
Pipe
Shower Head
1.1. The hot water service must always
be connected to the inlet marked
"HOT" in the base of the shower
control body.
1.2. The inlet elbows can be swivelled to
accept rising, falling or back entry
supplies, or any combination of two.
1.3. In choosing the position for the
shower control ensure that the fixed
shower head will be at a suitable
height for the application, and that
there is sufficient vertical distance
between the fixed shower head and
the base of the cold cistern to produce
an acceptable shower.
1.4. Flush the incoming hot and cold
water supplies before connection of
the shower control .
1.5. Use the 2.5 mm A/F hexagon wrench
(supplied) to loosen the grubscrew
and separate the backplate from the
shower control.
1.6. Fix the backplate to the wall with the
supplied fittings if appropriate.
1.7. Fit the shower control to the
backplate, align the shower control
body as necessary and tighten
grubscrew.
1.8. Connect the hot and cold water
supplies to the shower control 15mm
compression fittings.
Note! Care must be taken when
tightening compression nuts so that
you do not damage the plated
surfaces.