Table of Contents
Advertisement
INSTALLATION
Precautions before Installation
•
Before installation, ensure toilet wall, floor tile, ceramic toilet has been completed,
bathroom should supply water and power socket nearby toilet.
•
Water pressure should be between 0.06Mpa (flow) - 0.75MPa (Static), water
temperature 5°C - 35°C.
•
In case of transportation in subzero (freezing) condition, please put the product in a
warm place and wait for any residual water to thaw before installing.
•
Connect daily-use water pipe only. Use tap water or drinkable well water only. Do
not connect to recycled water or industrial water supplies, due to possible
contamination as this would cause jamming or internal damage.
•
Be sure to use T valve with filter.
•
Do not connect to electricity and turn on before finishing installation.
1.
Install T valve with filter
•
Lock inlet valve to remove water pipe (picture 1).
•
Connect T valve and inlet valve (picture 2).
•
Install flush tank and inlet pipe (picture 3).
Water pipes
T Valve with filter
Valve
OFF
Valve
Gasket
Flush tank
Valve
Advertisement
Table of Contents
