Kogan KASMABIDETA User Manual page 16

Smarterhome smart antibacterial wash & dry electric bidet toilet seat
Table of Contents

Advertisement

9. "Lady care"
10. "Child"
11. Position
12. "Super"
13. "Auto"
14. Water Temp
15. ECO
16. Deodoriser
17. Power
Note:
Idle mode means rear wash, front wash, dryer, flush, etc. are not enabled. Child wash,
one solution, strong wash, lady care must be enabled in idle mode.
Cleansing suitable for menstruation. In Idle mode, press this button to begin
function. The nozzle reaches out to work and water temp is set to the highest
level (39°C), water pressure is set to 2-level, cleaning position set as default.
Water temp/water pressure not adjustable, cleaning position is adjustable in
this mode, automatic ends after cleaning for 2 mins. Press Stop to end.
Warm water gentle cleaning, suitable for children. In Idle mode, press this
button to enter function. The nozzle reaches out to work and nozzle position is
at the front (5 level), mini water pressured level) and the water temp is mid-
grade (36°C) After washing 30s to end or press Stop to end. Under this mode,
cleaning position/ water pressure /water temp are not adjustable.
Select from five levels, adjusting the satisfied position to clean by pressing + or
– buttons.
Note: Under oscillating cleaning, the nozzle position adjustment is unavailable
Strong wash mode. In Idle mode, press this button to enter the powerful
washing mode, nozzle reaches out to work and the hole starts to effluent.
Water pressure is highest level, after washing 2mins to end. Press Stop to end.
"One solution", an automatic sequence performing Rear Wash (40 seconds),
Oscillate Wash (20 seconds), Warm Air Dryer (2 minutes), then stop. Press this
button to start in Idle mode, and press Stop to end.
The water temperature can be adjusted in 4 levels:
Room temperature
(No light)
Press the water temp button to cycle through the settings.
Low power mode. Press this button, the corresponding indicator blink on
control panel in standby, after leaving the seat for 1.5 minutes then enter
power saving mode. Under this mode, seat temp is kept at 25°C and the
settings before power saving are automatically restored the next time.
Press this button to start deodorising, indicator on the control panel lights up.
Press again to close.
Note: During drying, the deodorising function is temporarily stopped and it will
automatically start again after the drying is completed. When a person leaves
the seat, the deodorising function will continue to work automatically after 90
seconds.
Press this button to enter standby mode. All lights will be off. When pressed
again, the device will power on and the Power indicator light will be on.
33°C
36°C
(Blue)
(Green)
39°C
(Red)

Advertisement

Table of Contents
loading

Table of Contents