Table of Contents
Advertisement
7.7
Tetraclip
This is a special quick release axle with a ring lever. It simplifies wheel removal for occupants with particular problems affecting their hands
and fingers. The quick release words by turning the ring lever 90°
When the wheel is seated, the ring lever must be set as in figure 1, i.e. turned by 90° with respect to the axle.
To remove the wheel, turn the ring lever so that it aligns with the axle as shown in figure 2.
To engage the wheel, the ring lever must be aligned as in figure 2. Insert the wheel and turn the ring lever by 90° as in figure 1.
Checking the quick release axles of the rear wheels is one of the procedures that the occupant should perform
periodically.
If the quick release axles are not correctly positioned and fastened, they may work loose during normal operation and the
wheel could accidentally come off, causing the wheelchair to overbalance with possibly injury to the occupant.
See also chapter "Quick release rear wheels".
7.8
Tray
This accessory can be assembled only if the wheelchair is equipped with armrests.
To install the tray, loosen bolt A of the support S on each side of the wheelchair until the hole is free to let the post go through.
Insert the posts parallel into the supports and slide the tray in to the desired depth.
Finally, tighten the bolt A of both support S.
Before using the tray, make sure it is firmly fixed. Try to move it to-and-fro: if it does not move, it is ready for use.
To remove the tray, loosen the bolt A of the support S on each side of the wheelchair and slide it off.
1
2
B
A
Joker Energy / Noir 2.0 32
Advertisement
Table of Contents
