Push Buttons - Belitronic BJ5000 Ex Manual

Buttons [P]rog [E]enter [Z]ero [A]uto [U]p [S]stop
The [P]rog button is used in all display screens to get to the next display in chapter [P]. Since
Ex has more than 180 images, all images are grouped into smaller loops. Pressing the [P]rog
from the Main screen will first show the choice of Fish program. Future press then shows
screens for the selected Fish program.
The [E]nter button leads from Main screen to the menu system (Chatpter [E]) with a variety
of settings for both Fishing programs and everything else in the machine, such as Display
Contrast, Light and Sound. Inside the menu system, press the [E]nter button directly back to
the Main screen. In network, the button is used to access Group screens (hold button in).
[Z]ero button has two functions: A short press resets Line length, which will then become
Zeropoint. If the button is pressed for three seconds, a Reset menu will appear. See chapter
[Z] for more details.
To the right of the panel there are three buttons to "drive" the machine.
[A]uto button. A short press puts Ex in the Machine mode called Automatic mode. The
machine starts working according to the selected Fishing program (delayed start of
Autopause [E2]) and records catch according to set criteria. If the button is
held in, the line runs out without any brake at all. If the button is pressed repeatedly within 1
second in Auto mode, the Catch depth memory is cleared.
[U]p button is used to set Ex in the Machine mode called Manual mode. (Depends on
PAUSE MODE – Activates when [E445]) A short press starts or stops the motor. If the
button is pressed, the motor will run continuously until it is released. The motor also stops if
the counter comes to Zeropoint or if the wheel is stopped by Stop At Pulley [E442] or Stop
At Sea [E443]. In Auto mode, the button can be used to enable Pause mode.
[S]top / Down button is used to set Ex in the Machine mode called Manual mode (Depends
on PAUSE MODE – Activates when [E445]) and always stops the motor. As long as the
button is pressed, BRAKE force is applied to the wheel, which now should be easy for the
sinker to pull out. When the button is released, the DRAG force is applied on wheel which
should stop.
Button [1]-[6] (DRAG, CATCH och BRAKE)
The buttons below the display [1] - [6] have five different functions, but primary function is
marked with symbols above for them. Directly accessed from Main screen.
The symbol means DRAG. Refers to the force
applied to wheel when the line is stopped (in
pause, or manual mode) or pulled by motor.
The symbol means BRAKE and is the constant
braking force on the wheel to prevent line tangle
when line is released. A significantly weaker
power than DRAG.
The symbol means CATCH. A measure of how
heavily the engine must pull before the machine is
to register catch and start dragging the catch.
Read more in chapter Machine - 4
PUSHBUTTONS
Machine - 2
Figure 1. The symbols.....
DRAG CATCH BRAKE