Maintenance; Accessories - Belitronic BJ5000 Ex Manual

The clutch should be cleaned at regular intervals, at least once per year. If the line does not run off when
[A]uto is pressed, then you should check the clutch. It could be dirt and grime that are affecting the clutch.
The same thing can happen when the machine has not been used over a longer period of time. To clean
the clutch do the following. Remove the centre screw that holds the wheel in place. Carefully remove the
wheel. The armature plate is loose, so avoid loosing this, especially if you are doing thin on board the
boat. Pull the rotor from the axel, this can sit very good, but often is quite easy to remove. Clean all of the
parts with degreasing chemicals such as alcohol, technical spirit, acetone ect. Rub the armature plate and
the rotor carefully with emery paper.
Check once per year to see if damp
has entered the machine. Loosen
the 8 screws and remove the front
case.
Look for condensation and possible
corrosion on the display/main board.
If you see signs of condensation,
then let the machine dry out. A new
silicone seal is recommended after
opening especially if there were
signs of condensation. Use some
Teflon or similar on the screws as
stainless steel and aluminium do not
mix very well
Mounting pole
Diameter 40mm
or 50mm.
Mackerel wheel
Power supply cable
4x2,5mm² 7 meter or
Running meter

MAINTENANCE

ACCESSORIES

Outrigger
Diameter 30mm or
Diameter 30mm
50mm
Length 1000 mm
Cover
Information 4
Clutch
Coil
Rotor with lamel
Red
Hooks
Lines
Monofilament and
Dyneema 80-160Kg
Armature Plate
Pulleys
Black Blue
Sinkers