Mackerel And Squid Fishing Program; Two New Features Are Used; Programming Of Mackerel Fishing - Belitronic BJ5000 Ex Manual

This program is used for trolling mackerel and is also used
for squid fishing. Jig length is not used in this program
because line is hauled up to Zeropoint each time motor
starts. Every time lines heads down the Fishing depth is
reduced, if desired, to a minimum Fishing depth.

Two new features are used...

• Deep reduction[P]5[PP] is the reduction of the Fishing
depth for each time the line has been hauled up to
Zeropoint. This attract the fish against shallower water,
which allows for faster catch retrieval.
• Minimum depth. Reducing the Fishing depth to the
Zeropoint would not work well. Minimum depth is the
shallowest Fishing depth that will be used.
Example of wheel behavior with following settings...
• Fishing depth is 50 meters.
• Depth reduction is 5 meters.
• Minimum depth is 30 meters
When [A]uto is pressed.
• The machine releases to 50 meters. Brakes up and then pulls up the entire line to Zeropoint.
• Next release will be to 50-5 = 45 meter. Brakes up and then retracts the entire line again.
• Ex will continue reduce the Fishing depth until...
• Reduction of Fishing depth gets above 30 meter. Reduction is stopped and 30 meter will be set as
Fishing depth for all further fishing, until next press on [A]uto button.

Programming of Mackerel fishing...

• Press [P]rog and make sure top row shows "Fish program". Change with button [3] and [6] until row 3
shows "Mackerel fishing".
• Press [P]rog, set Fishing depth.
• Press [P]rog, set Depth reduction.
• Press [P]rog, set Minimum depth.
• When done, press [P]rog or [E]nter for Main screen
In Mackerel fishing, the Catch depth is not shown, but Catch registration on High load, and Low load
is still active in order to enter Catch mode which gives more options to variate motor power and speed.
For available Catch Detection Sensors in this program, see Table 1 on page Machine - 4
Screens in Mackrel / Squid program
Pictures
Line out
Fish program
Depth reduction
Minimum depth
Depth pause
[P]5 MACKEREL AND SQUID FISHING PROGRAM
Min
0
1
0
1
Mackerel / Squid program
The diagram shows theoretically how the sinker is drawing
on an echo sounder image, with the depth of the vertical
axis and the time on the horizontal.
Max Factory Step
999 -
Makrillfiskeprogram
10 2
999 5
Från Menu [E]
10 1
[P]5
Minimum depth
Depth reduction
Unit
1 M/Fm/Ft Main screen
[P]5
1 M/Fm/Ft [P]5 [P]
1 M/Fm/Ft [P]5 [PP]
1 M/Fm/Ft [E2 P]
Diagram 5
Depth
Time
Navigation