Dim; Line - Belitronic BJ5000 Ex Manual

Main screen
Navigate [E]
When all the fishing line is mounted on the wheel, the fishing line diameter and diameter of amount on wheel
must be fed in as accurately as possible. This allows the machine to calculate the amount of line that's
released, showed as LINE OUT as accurately as possible.
DIM – Dimension [E41] tells the machine how wide the wheel is, measured in millimeters on the inside of
the line. Factory default is 80mm.
LINE – Line diameter [E42] is the diameter of the fishing line in millimeter. If several lines with different
diameters are used on wheel the most important line to tell is the line going on and off the wheel during
jigging. Line at inner wheel diameter that never comes of the wheel does not matter at all. Also in the other
end, the few meters with hooks does not have much impact.
An example: If half of the line going into water during fishing is 1.2mm and the other half is 1.0mm, the best
results can be obtained with an average value like 1.1mm in this case. Alternatively, the diameter of the line
that is mostly used in water.
LINE – Outer diameter [E42 P] is how much line is on the wheel.
Not in meters, fathoms or feet, but the outer lap's diameter in
millimeters on wheel. To help determine this, there are three holes
in the wheel. These correspond to the values 160, 180 and 200mm
and indicate the diameter on wheel. Enter an estimated value. The
wheel has a largest outer diameter of 230mm. Putting more line
then 200mm might cause line tangle though.
Table shows units and value limits. See [E654] for menu detail level setting. Some screens are not visible if simple view, or normal view are Chosen .
Screens
WHEEL – Width
LINE – Line diamter
LINE – Outer diameter
DIM [E41] - LINE [E42]
Menu [E4]
Min Max Factory
WHEEL – DIM [E41]
1 99 80
WHEEL – LINE [E42]
1,5 5,0 1,4
130 400 170
[E41] – [E42]
Hole's for easier deciding the
amout of line on wheel
Step Unit
1 mm [E41]
0,1 mm [E42]
1 mm [E42 P]
Navigation