Catch Depth And Catch Depth Memory; Catch Depth Memory In Network; More About Network - Belitronic BJ5000 Ex Manual

CATCH DEPTH AND CATCH DEPTH MEMORY

Catch depth. In all Fishing programs except the mackerel [P]5 and Mackerel With Jig [P]6
programs, the Catch depth might be displayed while Ex is in Catch mode. This is optional and is
controlled by Show Catch depth [E3PPP PPP]. If enabled, the Catch depth screens and Main
screen is displayed alternately every 3 seconds during Catch mode. At the same time, the buzzer
may sound for audible notice, depending on BEEP – At catch [E63] setting.
Catch Depth Memory.
Registered Catch depth is memorized during a time Cooperation time [E651 PPP PPP P] from
time catch occurs. This time is shared to the entire network and is therefore located in MENU -
MORE - NETWORK. As long as the time and memory has not ran out of time, a "M" appears in the
display next to the Auto Symbol, for "Catch Memory"
Catch depth memory affects the machine in such a way that the machine's original Fishing
depth and Jig length is replaced with a calculated value so that the Fishing area is centered
around the Catch area. For example, if the Catch detection occurred at 50 meters and the Jig
length is 10 meters, the machine's Fishing depth will change to 55 meters. Future jigging will take
place between 55-45 meters, and Catch detection depth 50 is in the middle. When the next
Catch registration is made, the memory is replaced with a new calculation and the Cooperation
time [E651 PPP PPP P] restarts. When the Cooperation time [E651 PPP PPP P] runs out, the
machine returns to its original settings for Fishing depth, and Jig length.
If the Catch depth memory is not interesting, for example, false catch, then the [A]uto button can
be pressed a second time within 1 second. This will restore the original settings again and the "M"
shall dissapear.
Catch depth memory can be permanently disabled by setting Cooperation mode [E651 PPP] to
"Out". To do this, the Communication mode[E651] first has to be activated, "Master" or "Slave".
When change is done, turn off network connection by setting Communication mode[E651] to
"Out".
Machine no 5.
Symbol for Catch memory
This machine has detected catch.

Catch depth memory in network.

When Ex is connected into a network, the machine's Catch depth memory can be shared
(depends on Cooperation mode [E651 PPP]) with other machines within the same Group [E651
PP]. In the same way as the Catch detecting machine, the other machines' Depth and Jig length
will be replaced during the Cooperation time by adopting the settings from the last machine in the
Group that detects catch. Machines that helps another machine shows that machines address,
instead of the "M". In the example above, machine number 5 has detected catch. When the
Cooperation time expires, all machines return to their original settings.

More about network.

• Only one Catch depth memory is used in each Group. However, up to 6 groups can be used,
all with their own Catch depth memory.
• Machine detecting the catch last, decides where machines in the Group will fish. When a
machine detects a catch, the machine's settings will apply to all machines in the group. It then
writes over previous Catch depth memory and Cooperation time.
Machine 1,2,3,4 or 6.
Symbol for Catch memory
This machine now helps machine no 5.
Machine - 5