Approval; Electrical Installation - Belitronic BJ5000 Ex Manual

This machine BJ5000 is produced by Belitronic Sweden AB in Lunde Sweden in accordance with the
appropriate rules for CE approval and marking within EU and the EEC. The serial number is printed on
the outside label and also on the label under the gearbox. The machine is only meant for fishing. It must be
mounted in such a way that no danger occurs when in use. It is very important that the spool, line and
hooks cannot come in contact and injure the operator of the machine.
The emergency stop button must be easily accessible. Check daily that the emergency stop is working.
The machine must be connected to either a 12 or 24v DC, the power source should be a Lead Acid
Battery or equivalent ( see the chapter ELECTRICAL INSTALLATION)
The machine shall only be used by those who have read and accepted the contents of this user manual.
INSTALLATION
Upon installation, take particular care with the
mechanical, but most importantly the electrical
connections. If you are in doubt, contact a
qualified electrician. Mount your BJ5000Ex with
the supplied 40mm U-Bolts and brackets. The
brackets can be attached to either side of the
machine. Mount the brackets first on the
machine with the supplied M8 bolts, washers
and rounded nuts. Do not over tighten.
Secondly use the supplied U-Bolts around the
tubing with washers and nuts. Now check
tightness of all the nuts.
Make sure that the EMERGENCY STOP button is pressed before connecting the machine to the battery.
For the warranty to apply, Ex must be connected to lead battery or battery type that can be charged from a
traditional generator found on most boats and cars. The reason for this is that Ex must be able to get rid of
the energy that arises from tough driving as the engine acts as a generator, which can lead to lead batteries.
However, power supplies AC/DC or DC/DC may not be used. They do not receive the power from Ex and
results in overvoltage that will damage Ex. The power cable should be connected directly to the battery
system. Possibly via a fuse and / or main switch. Ex is made for 12volt DC and 24volt DC battery system
with charging. Under 10 volts and over 30 volts can cause damage to Ex.
Avoid damaging the cable and bundling it with other cables. Cables bundled up together increases the risk
of interference between Ex and other instruments onboard. The rule "Use as less cable and joints as
possible". Maximum length of supply cable 4x2,5mm² at maximum motor load at 12 volt battery pole voltage
is around 15 meter. If charger is used (battery pole voltage 14,5volt) 35 meter is okay. Running at 24 volt
power supply longer length then 35 meter might be okay.
Interference may occur in other instruments or devices, look over cables and possibly move the machine if
problem occurs.
The two red wires are connected to the battery + and
the two blue to the – regardless of 12V or 24v.
INSTALLATION

APPROVAL

ELECTRICAL INSTALLATION

+
_
Installation - 1
Details for pole mount.
12v
10v
Volt DC
AC/DC
24v
30v