Subscribe to Our Youtube Channel
Related Manuals for Cumberland Curt-O-Matic
Summary of Contents for Cumberland Curt-O-Matic
- Page 1 Curt-O-Matic Emergency Ventilation System Installation and Operation Manual 4802-0103 Version: 3.0 Date: 09-24-20 4802-0103...
- Page 2 All information, illustrations, photos, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice. 4802-0103 Curt-O-Matic Installation...
-
Page 3: Table Of Contents
Chapter 3 Installation ............................10 Inside ..............................10 Outside ..............................11 Chain Adjustment Kit ..........................11 Electrical Connections ..........................13 Operating Instructions ..........................13 Troubleshooting ...........................13 AAII Auxiliary Input ..........................14 Wiring to a Thermostat .........................14 Chapter 4 Parts List .............................15 Chapter 5 Warranty ..............................17 4802-0103 Curt-O-Matic Installation... -
Page 4: Chapter 1 Safety
When necessary, you must consider the installation location relative to electrical, fuel and water utilities. Personnel operating or working around equipment must read this manual. This manual must be delivered with equipment to its owner. Failure to read this manual and its safety instructions is a misuse of the equipment. ST-0001-4 4802-0103 Curt-O-Matic Installation... -
Page 5: Cautionary Symbols Definitions
This symbol is used to address practices not related to NOTICE personal injury. This symbol indicates a general hazard. This symbol indicates a prohibited activity. This symbol indicates a mandatory action. ST-0005-2 4802-0103 Curt-O-Matic Installation... -
Page 6: Safety Cautions
Learn how to operate the machine and how to use controls properly. Do not let anyone operate without instruction. • If you do not understand any part of this manual or need assistance, contact your dealer. ST-0002-1 4802-0103 Curt-O-Matic Installation... - Page 7 Make sure all equipment is properly grounded. ST-0027-4 Sharp Edge Hazard • This product has sharp edges, which can cause serious injury. • To avoid injury, handle sharp edges with caution and always use proper protective clothing and equipment. ST-0036-2 4802-0103 Curt-O-Matic Installation...
-
Page 8: Safety Sign-Off Sheet
Below is a sign-off sheet that can be used to verify that all personnel have read and understood the safety instructions. This sign-off sheet is provided for your convenience and personal record keeping. Date Employee Name Supervisor Name ST-0007 4802-0103 Curt-O-Matic Installation... -
Page 9: Chapter 2 General Information
5. Simple 3-wire hook-up. 6. 5 Minute (approximately) time delay. 7. Curt-O-Matic III can be hooked-up to your alarm systems electronic audible to signal alarm if arm on system should drop. When the Curt-O-Matic is connected and activated, the arm may release at any time. -
Page 10: Chapter 3 Installation
Figure 3A Curt-O-Matic III Inside Winches mounted on the post inside house: Curt-O-Matic should be mounted at least 16" above the winch. Mount the winch release lever (11) as shown in Figure 3B on Page 11. Place the cable loop (7) in the Curt-O-Matic load slot. -
Page 11: Outside
Outside Winch mounted on the outside corner of the building: If this setup is used with a Power-Trak, the Curt-O-Matic should be mounted on the lower U-bolt on the corner bracket while using the handle J-Hook (10). (See Figure 3B.) Otherwise, mount the unit above winch in a convenient location. - Page 12 • Make sure the Quick-Link does not reach the curtain roller before the chain is fully extended. • Verify that the winch or winch handle can not become tangled with the cable and/or chain. Relocate the cable or chain if necessary. 4802-0103 Curt-O-Matic Installation...
-
Page 13: Electrical Connections
Curt-O-Matic II - 240 volt models should be connected to the fan circuit. Curt-O-Matic III - 240 volt models should be connected to the fan circuit. The Curt-O-Matic III can be connected to the AAIII, farm hand alarm or other N.O. or N.C. alarm systems using the Com., N.O., and N.C. -
Page 14: Aaii Auxiliary Input
3. Installation AAII Auxiliary Input When connecting a Curt-O-Matic to an AAIII auxiliary input, use WHITE to connect to GND, use RED to connect to SIG. BLACK will not be used. (See Figure 3E.) Connecting to an AAII Auxiliary Input... -
Page 15: Chapter 4 Parts List
4. Parts List Curt-O-Matic II Product Numbers Part # Model # Description Electrical 6608-0100-HH CM-2-120-K-0 CM-2 120V 50/60 Hz 120V, 50/60 Hz 6608-0101 CM-2-120-K-S CM-2 120V 50/60 Hz, Single with T-Stat Assembly 120V, 50/60 Hz 6608-5005 CM-2-208-X-S CM-2 208V 50/60 Hz, Single with T-Stat Assembly... - Page 16 NOTES 4802-0103 Curt-O-Matic Installation...
-
Page 17: Chapter 5 Warranty
GSI warrants, subject to all other conditions described in this Warranty, Service Parts which it manufactures for a period of 12 months from the date of purchase, unless specified in Enhancements above. Parts not manufactured by GSI will carry the Manufacturer’s Warranty. (Protein Limited Warranty_REV01_06 November 2018) 4802-0103 Curt-O-Matic Installation... - Page 18 This equipment shall be installed in accordance with the current installation codes and applicable regulations, which should be carefully followed in all cases. Authorities having jurisdiction should be consulted before installations are made. 1004 E. Illinois St. Assumption, IL 62510-0020 Phone: 1-217-226-4421 Fax: 1-217-226-4420 www.cumberlandpoultry.com...
Need help?
Do you have a question about the Curt-O-Matic and is the answer not in the manual?
Questions and answers