Step 3: Remove Gobo/Filter; Step 4: Insert New Gobo/Filter; Step 5: Insert Spring; Step 6: Align Module - ETC Source Four Revolution Rotating Wheel Module Quick Manual

Q u i c k G u i d e :
Step 3:
Step 4:
C A U T I O N :
Step 5:
Step 6:
Step 7:
Step 8:
Rotating Wheel Module Quick Guide
®
Source Four
Remove the gobo/filter, if present.
Insert the new gobo/filter in the frame. Use the hole in or near the frame (see
above for alignment hole locations) to align your gobo, if required.
To prevent cracking of glass gobos and for best image contrast, the silver reflective
surface of the gobo must face the lamp and the black surface of the gobo must face
the lenses. Prolonged use of the Rotating Wheel Module in Bay #2 may cause the
belt within the module to degrade. To ensure peak performance of the RWM, use
it in Bay #1.
Insert the spring into the frame. Ensure that the gobo/filter is held securely in
place and that the spring is fully inserted in the frame.
Align the module in the selected bay with the interface connector closest to the
center bay divider.
Guide the module gently into the bay making certain that the guide posts of the
module housing are properly aligned with the accommodating hole in the fixture
frame. Ensure that the module seats on the control card.
Tighten the screws securing the module by turning them to the right (clockwise).
Ensure that the screws are tightened completely.
Page 2 of 2
Revolution™ Rotating Wheel Module
Bay #1
Bay #2
Electronic Theatre Controls, Inc.