Table of Contents
Advertisement
Section 4 • Operation
Notice on Using Non-Vilter Oils
CAUTION
Do not mix oils. Failure to comply may result in
damage to equipment.
NOTICE
Vilter does not approve non-Vilter oils for use with
Vilter compressors. Use of oils not specifi ed or
supplied by Vilter will void the compressor warranty.
Due to the need for adequate lubrication, Vilter recom-
mends only the use of Vilter lubricants, designed spe-
cifically for Vilter compressors. Use of oil not specified or
supplied by Vilter will void the compressor warranty.
Please contact your local Vilter representative or the
Home Office for further information.
Operation
All operation (set-point adjustments, calibrations,
moni toring) of the compressor unit is done through the
mi cro-processor. For additional procedural information,
re fer to micro-processor manual (35391SC for Vission
20/20 Operating Manual or 35391CM for Compact
Logix PLC Software Manual).
VSS/VSM/VSH/VSSH • Installation, Operation and Maintenance Manual • Emerson • 35391SD
Software programming credentials shall only be
made available by the supplier. The user will only
have access to operational features established by the
supplier. Failure to comply may result in serious injury
Oil Inspection
Avoid skin contact with any liquid refrigerant or oil.
Wear rubber gloves and a face shield when working
with liquid refrigerant or oil. Failure to comply may
Avoid skin contact with oil. Wear rubber gloves and a
face shield when working with oil. Failure to comply
Inspect oil level through sight glasses on the oil separa-
tor, see Figure 4-1. Oil Operating Levels. Drain or fill oil
as required. For oil draining and filling procedure, see Oil
Charging and Oil Draining in Section 5.
Normal Operating Level
Maximum NON-Operating Level
Minimum Operating Level
Figure 4-1. Oil Operating Levels
WARNING
or death.
WARNING
result in serious injury or death.
WARNING
may result in serious injury or death.
4 – 1
Advertisement
Table of Contents
Troubleshooting
