Table of Contents
Advertisement
Section 3 • Installation
NOTICE
Vilter compressors are to be installed and connected
to the customer-provided piping. Vilter expects this
piping to be designed and built following ASME B31.3
Process Piping Guide, plus any other local applicable
codes, and that the installation will be performed by
qualifi ed personnel only.
Delivery Inspection
All equipment supplied by Vilter are thoroughly inspect-
ed at the factory. However, damage can occur in ship-
ment. For this reason, the units should be thoroughly
inspected upon arrival, prior to off-loading. Any dam-
age noted should be photographed and reported im-
mediately to the transportation company. This way, an
authorized agent can examine the unit, determine the
extent of damage and take necessary steps to rectify the
claim with no serious or costly delays. At the same time,
the local Vilter representative or the home office should
be notified of any claims made within ten (10) days after
its discovery. Refer to Compressor Unit Inspections Prior
To Installation for additional recommendations.
Lifting Point
Figure 3-1. Rigging and Lifting Points (VSS-2101 Compressor Unit Shown)
VSS/VSM/VSH/VSSH • Installation, Operation and Maintenance Manual • Emerson • 35391SD
Rigging and Lifting of Compressor Unit
When rigging and lifting a compressor unit, use proper
lifting device capable of lifting and maneuvering the
weight and size of the compressor unit. Use only
qualifi ed personnel and additional personnel and
lifting equipment (i.e. spreader bar) as required.
Failure to comply may result in death, serious injury
Only qualified personnel shall operate rigging and lift-
ing equipment. Ensure that the lifting device is capable
of lifting the weight of the compressor unit, refer to the
supplied Vilter General Assembly (GA) drawing.
To lift the compressor unit, use lifting points on com-
pressor unit frame to attach the lifting device, see Figure
3-1. There are a few points to consider prior to moving
the unit:
• Ensure that the weight is evenly distributed amongst
• Ensure that the lifting device is not obstructed by any
• Use additional personnel as needed to spot and aid in
• Ensure there is plenty of space to maneuver the com-
Lifting Point
WARNING
and/or damage to equipment.
the lifting device (i.e. lifting chains and spreader bar)
prior to lifting.
parts of the compressor unit to prevent damage to
components.
maneuvering the compressor unit.
pressor unit and a clear path to its location.
Use lifting chains/straps and spreader bar. Evenly
distribute weight. Keep lifting chains and spreader
bar clear of components to prevent damage.
3 – 1
Advertisement
Table of Contents
Troubleshooting
