Replace Power Supply - Siemens FC430 Upgrade Instructions

④
Remove the SensorFlash (SD card) from the transmitter. Insert the SensorFlash into a PC using the SD card
adapter and create a backup of all files from the card to a PC.
Note: Do not re-insert the SD card in the transmitter at this point. You will need the SensorFlash again later, see
Synchronize data (Page 8).

Replace power supply

Remove sensor cassette
①
Remove the two screws that hold the sensor cassette.
②
Pull out the sensor cassette to the position shown in the photo. Disconnect the cable by pinching the plug with a pair
of point nose pliers while carefully pulling out the plug.
FC430 upgrade instructions - Remote
A5E33338888-AG, 06/2016
3