Starting The Trash Pump; Stopping The Trash Pump - Briggs & Stratton 73017 Operator's Manual

Trash pump pro series
Table of Contents

Advertisement

Available languages

Available languages

Starting the Trash Pump

Use the following start instructions:
1. Make sure unit is on a flat, level surface and pump
chamber is primed.
2. Model 073017 — Turn fuel valve (A) to "On" position.
The fuel valve handle will be vertical (pointing toward
the ground).
A
Model 073018 — Turn fuel valve to "On" position.
3. Push ON/OFF switch (B) to "On" position.
4. Move engine speed lever (C) to "Fast" (
C
5. Move choke lever (D) to "Choke" (
6. Grasp recoil handle and pull slowly until slight
resistance is felt. Then pull handle rapidly to overcome
compression, prevent kickback and start engine.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
• When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
IMPORTANT: If excessive fuel is present in the air/fuel mixture
causing a "flooded" condition, move choke lever to "Run" (
position and pull handle repeatedly until engine starts.
7. Move choke lever to "Run" (
distance at a time over several seconds in warm weather
or minutes in cold weather. Let engine run smoothly
before each change. Operate with choke in "Run" (
position.
IMPORTANT: It may take a few minutes for trash pump to
begin pumping water.
Pump output is controlled by adjusting engine speed.
Moving the engine speed lever in the "Fast" (
will increase pump output, and moving the engine speed
lever in the "Slow" (
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (1.5 m) of clearance on all sides of trash
) position.
pump including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
B
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
) position.

Stopping the Trash Pump

1. Move engine speed lever to "Slow" (
2. Push on/off switch to "Off" position.
3. Turn fuel valve to "Off" position.
D
• DO NOT stop engine by moving choke control to "Choke"
position.
) position a short
) direction will decrease pump output.
WARNING
Contact with muffler area can result in serious
burns.
Exhaust heat/ gases can ignite combustibles,
structures or damage fuel tank causing a fire.
WARNING
Backfire, fire or engine damage could occur.
)
)
) direction
) position.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

73018

Table of Contents