Table of Contents
Advertisement
12
General safety guidelines
Combustible gas
Combustible gas
Batteries
Wear ESD-preventive gloves, an ESD-preventive wrist strap, or ESD-preventive
clothes to avoid personnel injury or damage to a device. When a warning indicates
an electrostatic sensitive area, when operating a device you must take
ESD-preventive measures. To prevent the devices from damage, pay attention to
the following during operations:
Do not touch devices with bare hands because the ESD from the human body
■
may damage the electrostatically sensitive elements on a board.
Electronic circuits are prone to damage caused by ESD. When dealing with a
■
disk, especially a raw disk, wear an ESD-preventive wrist strap, ESD-preventive
gloves, and ESD-preventive suit. Touch only the edge of the disk.
Use appropriate ESD-preventive bags when picking up, putting down, and
■
transporting equipment or parts.
To prevent short-circuits, do not leave or drop screws or other metallic parts in the
chassis.
When you install or maintain a device, follow regulations about the use and
placement of tools. You can avoid short-circuits of the devices that are caused by
metallic tools.
See "Combustible gas" on page 12.
Never place or operate a device in an environment with combustible or explosive
gases, or smoke.
Operations to any electronic devices in the presence of combustible gases cause
an extreme danger.
See "Batteries" on page 12.
Follow the safety precautions for operating lithium (Li-ion) batteries against personnel
and device damage during installation and maintenance of Veritas products.
Be sure that you use correct replacement batteries. Otherwise, an explosion may
occur.
Only use batteries of the same or a similar model as recommended by the
■
vendor.
Deal with the waste batteries according to standard instructions.
■
Do not put a lithium battery into a fire.
■
Advertisement
Table of Contents
Troubleshooting
