General Information About The Assembly Of Drive Systems; Assembly Of Transmission Elements On Solid Shafts - Lenze L−force GST Operating Instructions Manual

4 Mechanical installation
Mounting

General information about the assembly of drive systems

4.4.2 General information about the assembly of drive systems
(
Stop!
The lubricant fill quantity of the gearboxes is matched to the mounting
position. The mounting position indicated on the nameplate must be observed
to avoid damage to the gearbox.
Take safety measures prior to any operation:
ƒ
– Disconnect the machine from the mains, ensure standstill of the drive system and
avoid any machine movement.
– Check the proper state of the drive system. Never install and set up damaged drive
systems.
– Check the combination of drive function and machine functions. Check the
direction of rotation (see Fig. 2).
The mounting surfaces must be even, without torsion, and free from vibration.
ƒ
Align the drive system on the mounting surfaces exactly with the machine shaft to
ƒ
be driven.
– Ensure that the assembly is without torsion to avoid additional load.
– Compensate for minor misalignments by using suitable flexible couplings.
Support the reaction torque appropriately.
ƒ
Fixings of accessories and attachments must be secured against loosening.
ƒ
We recommend that screw connections are glued.
4.4.3

Assembly of transmission elements on solid shafts

Draw the transmission elements onto the output shaft only by using the centering
ƒ
thread.
(
Stop!
Shocks and blows to the shafts damage the roller bearings.
22
l
BA 12.0023−EN 6.0