Advertisement
Mounting the grinding wheel
Always disconnect the device from the power supply before attaching, removing or replacing a
grinding wheel. Also make sure that the wheel guard is safely locked in place.
Place the inner flange and the grinding wheel on the shaft. Screw the flange nut onto the
thread and tighten it with the wrench supplied.
To remove the grinding wheel, all you have to do is reverse these steps.
Flange nut and inner flange
The device has a threaded shaft to which accessories can be attached; a matching flange nut and in -
ner flange are also supplied. Never replace them with parts of a different size or of inferior quality, as
otherwise the safe operation and functionality of the device can no longer be guaranteed. A suitable
wrench with which the flange nut can be tightened is also included.
Lateral handle
The side handle is used to guide the device evenly and can be attached either to the right or left of the
housing.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№
Name
1
Wheel guard
2
Locking screw
3
Cover
№
Name
1
Flange nut
2
Grinding wheel
3
Inner flange
№
Name
1
Grinder wrench
2
Shaft base
Item 62422, 62426
Page 5
03
2021-1
Advertisement
