Add Additional Memory To The Workstation; Prerequisites - Honeywell Z4 G4 Planning, Installation And Service Manual

Chapter 5 - Servicing
5. Insert the second LCNP4e2 card.
6. Replace the cardholder and card retention arm, and ensure that the tab locks in its place.
7. Replace the workstation cover and place the workstation in the furniture. Refer to the section,
Installing
5.4

Add additional memory to the workstation

Refer to the section
5.4.1

Prerequisites

Perform all necessary procedures in section
1. Shut down the workstation.
2. Disconnect power from the workstation and disconnect the attached cables.
3. Remove the workstation from furniture.
4. Access the inside of the electronics enclosure.
5. Disconnect cables from the card being replaced.
WARNING
Memory is electrostatically sensitive. Use a grounding strap and grounded work surfaces and
equipment when handling these components. Store and transport parts only in electrostatically
safe containers.
for installing the workstation in the furniture.
Memory configuration for information about memory module configuration.
Accessing the enclosure of the
- 67 -
workstation.