Adding Additional Memory Card - Honeywell R5500 Planning, Installation And Service Manual

Chapter 5 - Servicing
7. While wearing a grounded ESD wrist strap, unlock the Video board PCI bracket notch, grasp the
video card in PCIe Slot 4 at the corners and gently remove the existing card.
8. Insert the replacement LCNP4E/LCNP4E2 board assembly in the PCIe slot 4 as illustrated in the
following image.
9. Lock the PCI bracket notch and insert the outer riser board on motherboard.
10. Replace the card holder and card retention arm making sure the tab locks into place.
11. Replace the workstation cover and place the workstation in the furniture using the appropriate
installation procedures in section Installing.
12. Reconnect the cables to the video card.
13. Restart the operating system.
5.3.2

Adding additional memory card

Perform the following procedure to add additional gigabyte of memory to the workstation, refer to
memory configuration for memory module configuration.
ATTENTION
Ensure that you do not mix the displays like the CRT and FPD.
- 48 -