Connect Remaining Cables And Power; Connecting To The Experion Orion Console Monitor; Single Screen 4K Display Layout Using Quadro P620 For Experion Orion Console - Honeywell Z4 G4 Planning, Installation And Service Manual

3.6.2

Connect remaining cables and power

NOTE
A Local Control Network Processor (LCNP) board and LCN Media Access Unit (MAU) are no
longer used if the Workstation has been upgraded to be an ELCN node.
To connect the remaining cables to the workstation
1. If you have an IKB that uses the OEP/IKB adapter, connect the PS/2 keyboard cable from the
OEP/IKB adapter to the keyboard PS/2 port.
2. If you are not using Fault Tolerant Ethernet (FTE), connect the Ethernet cable to the RJ-45
connector on the Network Interface Card.
If you are using FTE, you must connect the FTE cables according to the instructions in the Fault
Tolerant Ethernet Installation and Service Guide.
3. Connect the LCN MAU cable to the MAU connector on the LCNP4e2 card.
4. Connect any USB devices or hubs to the USB ports; you can also connect the USB IKB. The USB
device connected to USB ports works only if the driver is installed on the operating system.
5. Secure any loose cables, and verify that all cables have proper strain relief.
3.7

Connecting to the Experion Orion console monitor

3.7.1 Single screen 4K display layout using Quadro P620 for
Experion Orion Console
When this platform is installed with an nVidia Quadro P620 video card on the Experion Orion console,
connect the monitor to the video card Output#1 using an mDP to DP converter.
R4xx Single Screen Connection
FPD
1
NA
NA
NA
Serial
no Slot Card
5 4 LCNP4e2
6 5 Serial port
Connection from Connection to
Serial port from MAU
LCNP4e2
D-type male 9 pin female connector of interface
connector (serial cable to IKB/OEP keyboard
port) adaptor
- 39 -
Chapter 3 - Installing
Cable Port
1
2
3
4