Chapter 5 - Servicing; Accessing The Enclosure Of The Workstation; Shutdown Workstation; Remove The Workstation From An Icon Series Console - Honeywell Z4 G4 Planning, Installation And Service Manual

CHAPTER
5

Accessing the enclosure of the workstation

l
Servicing the LCNP4e2
l
Replacing/adding optional components
l
Installing the second LCNP4e2 card
l
Verifying the BIOS settings
l
NOTE
A Local Control Network Processor (LCNP) board and LCN Media Access Unit (MAU) are no
longer used if the Workstation has been upgraded to be an ELCN node.
5.1 Accessing the enclosure of the workstation
This section contains procedures for removing the workstation from Classic console, and a cabinet.
The procedures apply to the workstation.

Shutdown workstation

l

Remove the workstation from an Icon Series console

l
Open the enclosure
l
5.1.1 Shutdown workstation
1. Perform a double SHUTDOWN of the native window and a SHUTDOWN of the Windows operating
system. Refer to the Global User Station User's Guide for instructions.
2. When the RESTART message appears on the monitor, place the Power Entry breaker in the OFF
position (applicable to consoles only).
3. Turn off power to the computer if it has a separate power switch, and disconnect the AC power
cord.
4. Turn off power to the monitor(s) and the printer, if applicable.
5.1.2 Remove the workstation from an Icon Series console
To remove the workstation from an Icon Series console
S
ERVICING
- 52 -