Honeywell Z4 G4 Planning, Installation And Service Manual page 32

Chapter 3 - Installing
3. If the retaining brackets are attached, loosen the two captivated fasteners on each retaining bracket
and remove them.
4. Verify that the console mounting rails are clear of any installed cables.
5. Place the workstation on the mounting tray such that the front edge of the workstation bezel is flush
with the front surface of the mounting tray and centered side-to-side.
6. Slide the workstation all the way in until the back of the chassis touch the flanges on the side
mounting brackets. Ensure that the workstation front bezel protrudes approximately 38 mm[1.5"]
beyond the front surface of the side mounting brackets.
7. Place one (1) foam wedge handle assembly between the left side mounting bracket and the left
side of the workstation (when viewed facing the workstation front bezel) with the workstation
approximately 7,6 cm [3 inches] forward from its fully install position.
ATTENTION
In the following three photos, a different workstation is shown. The HP Z4 G4-based
workstation is mounted using the same procedure.
- 32 -