Replacing/Adding Optional Components; Replace/Add Video Card - Honeywell Z4 G4 Planning, Installation And Service Manual

Chapter 5 - Servicing
8. Reconnect the LCN MAU cable and all necessary cables.
9. Power on the system.
5.3

Replacing/adding optional components

This section provides instructions for adding or replacing optional components in the workstation. The
video card is located in the PCI-E slot 1 in the workstation.

Replace/add video card

l
Replace/add the power adapter card
l
Add additional memory to the workstation
l
5.3.1 Replace/add video card
Prerequisites
Refer to the section
video card in the PCI-E slot 1.
1. Shut down the workstation.
2. Disconnect power from the workstation and disconnect the attached cables.
3. Remove the workstation from furniture.
4. Access the inside of the electronics enclosure.
5. Disconnect cables from the card being replaced.
WARNING
Do not damage the EMI gasket fingers while removing/installing boards.
CAUTION
Use a grounding strap and grounded work surfaces and equipment when handling any
electrostatically sensitive components such as the video cards, NIC adapter cards, and SCSI
controller cards. Store and transport parts only in electrostatically safe containers.
Accessing the enclosure of the workstation and perform the following to access the
- 59 -