Adjust The Tilt - ETC ColorSource PAR Installation Manual

ETC Installation Guide
ColorSource PAR v1.7
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
4. Plug the power cord into the power source.
Data in
Power Up
Press any button to wake the display. The display shows the DMX address.
See Set the DMX Address on the facing page
You can press the Mode button to access the Presets/Sequences menu. See
Play Presets and Sequences on page 8

Adjust the Tilt

The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knob.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knob.
ColorSource PAR
Connectors on the previous page
Power in Power thru
Mode Up and Down
User interface
.
Page 6 of 12
Data thru
.
.
ETC