Adjust The Tilt; Set The Dmx Address - ETC ColorSource Spot Installation Manual

ETC Installation Guide
ColorSource Spot v1.7
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
4. Plug the power cord into the power source.
Power Up
Press any button to wake the display. The display shows the DMX address.
See Set the DMX Address below
You can press the Mode button to access the Presets/Sequences menu. See
Play Presets and Sequences on page 8

Adjust the Tilt

The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knobs.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knobs.
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See
ColorSource Spot
User interface
Mode
Data in
Power
in
Connectors on the previous page
Up and Down
Data thru
Safety cable
attachment
loops
Power
thru
.
.
RDM Values on page 11
Page 6 of 12
.
.
ETC