Laser Safety; General - MICRO-EPSILON scanCONTROL 30 Series Operating Instructions Manual

Laser Safety

2. Laser Safety
2.1

General

The scanCONTROL 30xx sensors operate with a
semiconductor laser having a wavelength of 658 nm
(visible/red) resp. 405 nm (visible/blue).
When operating the scanCONTROL 30xx sensors,
the relevant regulations according to IEC 60825, Part
1 of 05/2014 and the applicable accident prevention
regulations must be followed.
The laser warning labels for Germany have already
been attached. For other non German speaking
countries, an IEC standard label is included in deliv-
ery and the versions valid for the user's country must
be attached before the device is put into operation for
the first time.
i
If both warning labels are coverd over when
the unit is installed, the user must ensure that
supplementary labels are applied.
Laser operation is indicated by LED, see Chap. 3.3.
The housing of the optical senors must only be
opened by the manufacturer, see Chap. 9.
For repair and service purposes, the sensors must
always be sent to the manufacturer.
scanCONTROL 30xx
scanCONTROL
LASER RADIATION
DO NOT STARE INTO BEAM
OR EXPOSE USERS OF
TELESCOPE OPTICS
CLASS 2M LASER PRODUCT
IEC 60825-1: 2014
P ≤ 10mW, P ≤ 10mW; E≤ 6mW/cm²;
0 P
λ = 405nm; F = 0...25kHz, t = 7µs...∞
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR CONFORMANCE WITH
IEC 60825-1 ED. 3., AS DESCRIBED IN
LASER NOTICE NO. 56, DATED MAY 8, 2019
Fig. 1 Sensor with laser labels
LASER
APERTURE
Page 10