Warnings For The Installer - GiBiDi KUDA 150 Instructions For Installations

INTRODUCTION
The KUDA operator for swing gates is an electromechanical device that transmits motion to the gate by means of a
worm screw. It is locked when the motor is not running, it is necessary to install locks
doors .

WARNINGS FOR THE INSTALLER

Before proceeding with installation, fit a magnetothermal and differential switch with a maximum capacity of 10A
Ÿ
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3mm.
All the packaging materials must be kept out of reach of children since they are potential sources of danger.
Ÿ
The manufacturer declines all responsibility for proper functioning of the automated device if failing to use original
Ÿ
GIBIDI components and accessories suitable for the intended application.
When installation has been completed, always carefully check proper functioning of the system and the devices
Ÿ
used.
This instruction manual addresses persons qualified for installation of "live equipment", therefore, good technical
Ÿ
knowledge is required exercised as profession in compliance with the regulations in force.
Ÿ
Maintenance must be performed by qualified personnel.
Ÿ
Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
Ÿ
This product has been designed and constructed solely for the use indicated in this document. Any other use may
Ÿ
cause damage to the product and be a source of danger.
Verify the intended end use and take the necessary safety precautions.
Ÿ
Use of the products for purposes different from the intended use has not been tested by the manufacturer and the
Ÿ
operations performed are therefore on full responsibility of the installer.
Mark the automated device with visible warning plates.
Ÿ
Warn the user that children and animals must not play or stand near the gate.
Ÿ
Adequately protect the danger points, for example, using a sensitive frame.
Ÿ
Check proper installation of the earthing system; connect all the metal parts of doors, gates, etc. and all the
Ÿ
system components equipped with earthing plate.
Exclusively use original spare parts for any maintenance or repair.
Ÿ
Do not make any modification to the components of the automated device unless expressly authorised by GIBIDI.
Ÿ
Gi.Bi.Di. Srl reserves the right to change the technical data without prior notice in relation to product development.
Ÿ
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
UK
if fitted on blind/flush panel
9