Installation Warnings - GiBiDi AGO 400 Instructions For Installation Manual

10
UK
INTRODUCTION
Our compliments for your excellent choice. AGO electro-mechanical gear motor has been produced for reliability
and high quality.
This Manual will offer information you may need to install your gear motor assuring long-lasting performance
and to safeguard your safety.
HOWEVER, CAUTION IS UNQUESTIONABLY INDISPENSABLE
AND NOTHING IS BETTER THAN PREVENTING ACCIDENTS.
Gi.Bi.Di. Srl products have been made to conform with rules and laws in force at time of manufacture.

INSTALLATION WARNINGS

This manual is designed exclusively for the specialized installation expert in the criteria of construction
and equipment to assist in the protection against accidents in the installation and use of the gate; door and
automation of such gates (adhere to the rules and laws in force).
On completion, the installer should issue to the end consumer an instruction manual according to EN 12635.
Before proceeding with the installation, the installer must provide an analysis of the identification and
management of risks as per the standards EN 12453 and EN 12445).
All wiring of the various external electrical components connected to the automation (e.g. Photocells, flashing
lights, keypads etc.) must be carried out according to EN 60204-1 and the amendments made of the point
5.2.2 of EN 12453.
It is prohibited to do any repair or adjustment of the equipment if you have not taken all necessary precautions
to avoid possible accidents (example: power supply disconnected, engine block).
All mechanisms in motion must be equipped with appropriate protections.
The mains power line must be protected for maximum current in locked rotor condition.
Install the gear motor on gates that conform to EN 12604.
Perform the measure of strength developed by the gear motor and adopt the measures as per EN 12445.
Positioning photocells: These safety devices must be installed at a height not exceeding 70cm from the
ground and at a distance from the floor movement of the door of no more than 20cm.
Their proper functioning of the photocells must be verified at the end of installation according to Section
7.2.1 of EN12445.
Qualified people must carry out all repairs.
Keep the activation controls of automation out of reach of children. The controls should be installed at a
minimum 1.5m height above the ground and outside the range of actions of moving parts such as the gate.
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
AGO