Table Of Contents - Maytag MLG30 Installation Manual

In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gas fitter qualified or licensed by
I
the State of Massachusetts.
Acceptable Shut-off Devices: Gas Cocks and Ball Valves installed for use shall be listed.
I
A flexible gas connector, when used, must not exceed 4 feet (121.9 cm).
I
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1.
Important Information __________
IMPORTANT: A means of restraint must be used to prevent
straining of the gas supply when the dryer is moved.
An external means of power removal (disconnect device)
must be provided by the installer.
The dryer must be used only for drying water washed
fabrics.
The dryer must never be operated with any of the back
guards or service panels removed.
The wiring diagram for the dryer is located behind the front
control panel.
"Caution: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper
operation."
List of Acronyms _______________
HVAC Heating, Ventilating, and Air-Conditioning
in WC Inches of Water Column
UL Underwriters Laboratory
NPT National Pipe Thread

Table Of Contents ______________

Specifications .................................................................. 4
Installation Instructions .................................................. 5
Location Requirements ................................................... 5
Dryer Enclosure Requirements ...................................... 6
Fresh Air Supply Requirements ...................................... 6
Exhaust Requirements .................................................... 6
Electrical Information ...................................................... 8
Gas Information................................................................ 9
Preparation for Operation / Start-Up ........................... 12
Preoperational Test ........................................................ 13
Operating Instructions .................................................. 13
Shutdown Instructions .................................................. 13
Service / Parts Information .......................................... 14
Routine Maintenance ................................................... 14
Data Label Information ................................................. 15
3