Related Manuals for Maytag MLG35
Summary of Contents for Maytag MLG35
- Page 1 MLG35 Installation Manual RETAIN THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE Part No. 113249-2...
- Page 2 – L’installation et l’entretien doivent être assurés par un installateur ou un service d’entretien qualifié ou par le fournisseur de gaz. Maytag Co. 113249 - 2...
- Page 3 Fuel Gas Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1. The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1. 113249 - 2 Maytag Co.
-
Page 4: Table Of Contents
Cleaning ..............14 side. Adjustments ............14 Data Label Information .......... 15 List of Acronyms _____________________ HVAC Heating, Ventilating, and Air-Conditioning in wc Inches of Water Column L.C.D. Liquid Crystal Display L.P. Liquid Propane Underwriters Laboratory Maytag Co. 113249 - 2... -
Page 5: Specifications
N / A INLET PIPE CONNECTION 1/2” M.N.P.T. PER POCKET Shaded areas are stated in metric equivalents 8/28/12 NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. 113249 - 2 Maytag Co. - Page 6 Specifications _____________________________________________________________________ NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. Maytag Co. 113249 - 2...
-
Page 7: Installation Procedures
The dryer must be installed with adequate clearance for air openings into the combustion chamber. IMPORTANT: The dryer must be installed in a location/ environment, which the ambient temperature remains between 40° F (4.44° C) and 130° F (54.44° C). 113249 - 2 Maytag Co. -
Page 8: Dryer Enclosure Requirements
It is not necessary to have a separate make-up air opening for each dryer. Common make-up air openings are acceptable. However, they must be set up in such a manner that the make-up air is distributed equally to all the dryers. Maytag Co. 113249 - 2... - Page 9 IMPORTANT: Do not use screens, louvers, or caps on the individual ductwork must be at least 8-inches (20.32 cm). outside opening of the exhaust ductwork. IMPORTANT: No more than four dryers should be connected to one main common duct. 113249 - 2 Maytag Co.
-
Page 10: Electrical Information
Do not use aluminum wire, which could cause a fire hazard. The copper conductor wire/cable must be of proper ampacity and insulation in accordance with electric codes for making all service connections. Maytag Co. 113249 - 2... -
Page 11: Gas Information
Insert incoming black wire (L1) for the top pocket into the done by a qualified service technician. second from the right connection. MLG35 L.P. Conversion Kit: 884448 Insert incoming white wire (neutral) for the bottom pocket It is your responsibility to have all plumbing connections, into the third from the right connection. - Page 12 2,500 11.0 64,000 10.5 Shaded areas are stated in metric equivalents Gas valve’s internal regulator disabled. ** Information is per pocket/tumbler. *** Consult factory for elevations over 2,000 feet (610 meters) for correct orifice size. Maytag Co. 113249 - 2...
-
Page 13: Preparation For Operation / Start-Up
• Rotate the tumbler (drum) by hand to ensure it moves freely. • Check bolts, nuts, screws, terminals, and fittings for tightness and security. • Check that the vent is connected to the dryer and is exhausted to the outdoors. 113249 - 2 Maytag Co. -
Page 14: Shutdown Instructions
Clean any lint accumulation in and around the motor(s) NOTE: When ordering replacement parts from the Maytag casing opening. distributor or the Maytag Co. be sure to give them the Every 6 Months correct model number and serial number so that your parts order can be processed in an expeditious manner. -
Page 15: Data Label Information
____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ When contacting Maytag, the information on the data label ____________________________________________________________ is required to ensure proper service/parts assistance. The data label is located at the upper left rear of the dryer behind ____________________________________________________________ the back guard. - Page 16 Part No. 113249 2 - 09/05/12...