Advertisement
WOODLAND
SCENICS
Please follow the River Pass General Instructions which are enclosed in this kit. You
will be referred to the drawings and notes printed here. Please read through all instruc-
tions before beginning to build your kit.
Chimney
Glue chimney halves together. When glue is dry, sand or file bottom of chimney flat
and square. Glue to top of roof after roof installation.
RP12-4
(sand front edge)
®
Window Sprues
To remove window sprues, we recommend using Fiskars Diagonal Cutters. If not
available, use hobby knife with chisel blade. Lay part on flat surface, face up. Set
hobby knife with chisel blade on side of sprue. Use small hammer to tap hobby knife
and cut through each side of sprue from front only. Be careful not to cut window sash.
Clean sides with file (Fig. 1).
#RP12
River's Hotel
RP12-3
(sand both edges)
Fig. 1
cut
sprue
Advertisement
