Advertisement
WOODLAND
SCENICS
Please follow the River Pass General Instructions which are enclosed in this kit. You will be referred to the
drawings and notes printed here. Please read through all instructions before beginning to build your kit.
Chimney
Lightly sand bottom edge of chimney back until flat (RP7-1). Sand or file the smooth side of chimney
back and molded-in chimney front so back and front fit tightly and are flush with each other. Glue
together. When glue is dry, sand top of chimney flat.
Walls
Glue the four two-story walls together. Glue the four one-story walls together. Note that wall RP7-8
touches the sill on wall RP7-3. Cut off part of the sill so wall RP7-8 will fit flush to wall RP7-3. Sand
it smooth. Glue the two assemblies together as shown.
RP7-2
(sand both edges)
RP7-5
(sand non-brick detailed edge)
RP7-6
(sand both edges)
®
RP7-1
Dyden #2
RP7-4
(sand both edges)
RP7-3
cut off part of
window sill
RP7-8
(sand non-brick
detailed edge)
RP7-7
(sand non-brick detailed edge)
#RP7
Advertisement
