Advertisement
WOODLAND
SCENICS
Please follow the River Pass General Instructions. You may be referred to the drawings and notes printed
here. Please read through all instructions before beginning to build your kit.
Chimneys
Sand the smooth sides of chimney halves (RP10-7) so they fit flush with each other; glue together. When
completely dry, file or sand to and bottom, keeping edges flat and square so no rounding occurs. Glue
chimney to the top of roof after installation of roof.
Entry Doors
To remove "tabs" (necessary for molding purposes) from tops and bottoms of entry door (RP10-5), lightly
cut in the indentations by making several passes with a hobby knife (X-Acto). Be careful to not damage the
door frames (Fig. 1). Thin plastic strips are provided to make side panels for the entry door. To make these
panels, cut the plastic strips the height of the door, scoring with a hobby knife and snapping them off. Glue
the panels to the entry door at a slight outward angle so they glue behind the columns at the opening on the
wall. Check for fit while the glue is still flexible. Glue the entry assembly in place.
RP10-4
(sand front edge)
RP10-1
side panels
®
RP10-7
RP10-5
Don's Hardware
RP10-2
(sand front edge)
RP10-5
#RP10
RP10-3
(sand both edges)
Fig.1
tab
cut
cut
tab
Advertisement
