TechniSat DIGITRADIO 3 Operating Manual page 80

13.2 Alarm
The alarm switches the DIGITRADIO 3 on at the set time. 2 alarm times can be
programmed. The description of how to programme Alarm 1 serves as an example
13.2.1 Setting the alarm
> Press the Alarm 1/2 (31) button on the remote control.
1 x press for configuration Alarm 1.
2 x press for configuration Alarm 2.
[Alarm 1 Setting] appears on the display.
> Press the OK button to start configuring the setting.
> Use the P+ or P- buttons to select [Alarm on] item and press the OK button
to switch the alarm on.
If you want to switch off an already programmed alarm, select [Alarm Off]
here.
> The display shows [Time 06:00], and the first character is flashing. You can
now enter the alarm time. First select the hours with the P+/P- buttons and
press the OK button to accept. Then enter the minutes. Accept this, again by
pressing the OK button.
> Then enter the duration. Accept the input by pressing the OK button.
> You then enter the source. BUZZER, DAB or FM are available. Press the OK
button to accept the setting.
If you have selected DAB or FM, you can then enter whether or not you
want to be woken up by the last station listened to or by one from your
Favourites list.
> The next step is to set the repeat frequency. Here you can select from Daily
(every day of the week), Once, Weekdays (Mon. - Fri.) or Weekends (Sat. and
Sun.). Press the OK button to apply the setting.
> Finally, you can then set the alarm volume using the P+/P- buttons. Press the
OK button to confirm. The alarm is then saved.
The time must be read for the alarm to function properly. For more details, see
Section 14.1.
A bell symbol appears on the display if the alarm is active and the DIGITRADIO
3 is in Standby mode.
80