TechniSat DIGITRADIO 3 Operating Manual page 68

7.2.4 Calling up DAB+ stations from a memory slot
> To call up a station that you have stored in the FAV memory slots, briefly press
the FAV button and select a station slot (1...20) using the <, > buttons. Press
the OK button to play the station.
If no station is saved in the selected station slot, [(empty)] appears on the
display.
Alternatively, you can also use the relevant numeric key on the remote control
or the direct selection button on the device.
7.2.5 Overwriting/deleting a station memory slot
> Simply save a new station in a favourite memory slot as described.
When calling up the factory settings all memory slots are deleted.
7.2.6 Signal strength
> Briefly press the MENU button, use the < or > buttons to select the [Display]
item and press the OK button.
> Use the < or > buttons to select the [Signal strength] item and press the OK
button.
> Exit the menu by pressing the BACK button several times.
> The display shows the signal strength in the form of a bar graph. The mark
shows the minimum signal strength.
Stations with a signal strength below the required minimum signal intensity
are not transmitting a strong enough signal. Align the telescopic antenna as
described in Section 5.3.3 if required.
7.2.7 Manual setting
This menu item is used to check the reception channels and can be used to align the
antenna.
> Briefly press the MENU button, use the < or > buttons to select the [Manual
setting] item and press the OK button.
> Use the < or > and OK buttons to select a channel (5A to 13F). The signal
intensity will now be shown in the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now
be aligned to the maximum signal intensity.
Stations with a signal strength below the required minimum signal intensity
are not transmitting a strong enough signal. Align the telescopic antenna as
described in Section 5.3.3 if required.
68