TechniSat DIGITRADIO 3 Operating Manual page 79

In order to delete the programming when you are in programming mode,
press the Stop
programmed playback list, and to delete the programming, press the Stop
button 2x during playback.
Changing the source, or removing the USB, also deletes the programming.
12 Audio input
You can play sound on an external device via the DIGITRADIO 3 speaker.
> Connect the external device to the AUDIO IN port (16, 3.5 mm jack) on the
back of the device
> Use the MODE button to select the audio input. [AUX - In] appears on the
display.
Playback is controlled from the external device. Do not set the volume too low,
so as to prevent interference.
During AUX input operation, the device remains switched on, even if the
connected audio source is not providing a signal.
13 Other functions
13.1 Sleep Timer
The sleep timer automatically switches the DIGITRADIO 3 to Standby after the set
time.
> Hold down the MENU button and use the < or > buttons to select the [Sleep]
item.
> Press the OK button.
> Use P+ or P- to select a period after which the DIGITRADIO 3 should switch
off. You can choose between Off, 5, 10, 15, 30, 60 and 90 minutes.
> Press the OK button to apply the setting.
If you would like to check the time left while the sleep timer is active, just
open Menu > Sleep again. If you want to switch off an active sleep timer,
select Sleep > Off.
> Alternatively the SLEEP
button and start again. In order to end playback of a
button can be used.
DE
EN
FR
NL
79