Table of Contents
Advertisement
Install Option Cards
Option cards, including the
option card, and
installation into the Sensor IQ Breaker Panel. Installation instructions are provided with each individual
option card.
Install option cards
on both interior walls
of the low-voltage
box
The Ride Thru Option
or UPS Control
Backup Wiring Kit
installs in top left
mounting position
Note:
Note:
Installation
0–10V Dimming Control
Ride-Thru Option
card, and the
0–10V, DALI, and Contact Interface option cards
install in left or right bottom mounting positions
The panel shown above is mounted in a top-feed orientation. If your installation
requires bottom-feed mounting, your Ride Thru option or UPS Control Backup
Wiring Kit will be mounted on the lower right wall of the low-voltage box.
If you are installing a UPS Control Backup Wiring Kit and you do not see a 2.0 cm (3/
4 in) diameter wiring access hole on the side of the low-voltage box near the card
installation location,
contact ETC Technical
DALI Control
card,
UPS Control Backup Wiring Kit
Services.
Contact Input
option card,
are available for field
Ethernet Card
(factory installed)
29
Advertisement
Table of Contents
