Table of Contents
Advertisement
DALI Control
Note:
Contact Input
UPS Control Backup Wiring Kit
Introduction
The Digital Addressable Lighting Interface Control card (IQ-
DALI) controls 24 loops of 64 DALI-compatible ballasts in
broadcast mode. Each loop of up to 64 ballasts is linked one-
to-one with the panel circuit for power control.
The DALI ballast must be powered by an external DALI loop
power supply (supplied by others). This supply is connected
externally of the Sensor IQ panel. Each DALI loop requires its
own power supply and possibly more than one power supply
depending on the ballast load.
A single Sensor IQ Breaker Panel supports the use of either the 0–10V output control
option or a DALI option card, but not both in the same panel.
The Contact Input card (IQ-CI) provides the ability to directly
control the breakers using a momentary or maintained dry
contact input.
The UPS Control Backup Wiring Kit provides a way to connect
an auxiliary source of power to the Echo Power Control
Processor (PCP). The backup UPS will allow breakers to
change state as needed in emergency lighting control systems
where the panel must shed loads to avoid overloading the
emergency power source.
• Installation is limited to 64 DALI-compatible fluorescent
ballasts per DALI loop.
• The IQ-DALI Control card installs using stand-offs to the
inside wall of the low-voltage box.
• The IQ-CI card installs using stand-offs to the inside wall
of the low-voltage box.
9
Advertisement
Table of Contents
