Table of Contents
Advertisement
Power Control Processor
The Power Control Processor ships installed in the Sensor IQ panel. For information on setup and
programming, please see the
is available for free download at etcconnect.com.
Remove the protective film from the front of the Control Processor before use.
Low-Voltage Trough
The low-voltage trough is attached to the Power Control Processor box and is adjustable to
accommodate the number of wires required for low-voltage connections.
To adjust the trough:
1:
Remove the two screws securing the top plate in place.
2:
Slide the top plate to increase or decrease the size, lining up the holes on the top plate with the
holes on the low-voltage box.
3:
Reinstall the screws, making sure that the top plate and bottom plate are secured together with
at least one of the screws.
28
Power Control Processor Configuration Manual
Low-Voltage
Box
Low-Voltage
Trough
. All ETC documentation
Sensor IQ Installation Manual
Advertisement
Table of Contents
