Table of Contents
Advertisement
2 – – I I nstrument l l ighting
When the lights are on, the level of the
instrument lighting can be set to any
intensity by turning the knurled wheel
next to the switch.
3 – – H H eadlight r r ange c c ontrol*
With the electrical range control the head-
light settings can be matched exactly to
the load condition of vehicle. This pre-
vents oncoming traffic from being dazzled
more than is unavoidable. At the same
time the correct headlight beam setting
provides the best possible visibility for
the driver.
The headlights can only be regulated with
the dipped headlights switched on.
To lower the beams, turn knurled disc
from the basic position (–) downwards.
LIGHTS AND VISIBILITY
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
HANDLING INSTRUCTIONS
4 – – H H azard w w arning l l ights
The system also works when the ignition
is switched off.
Switch on the hazard warning lights if, for
example:
– Your vehicle stops because of a techni-
cal defect,
– You have an emergency.
– You reach the tail end of a traffic jam.
When the hazard warning lights are
switched on, all four signal lights flash
simultaneously. The warning lamps for
the indicators and a warning lamp in the
switch will also flash.
Note
l l egal
r r equirements
employing s s uch s s afety m m easures.
AR0-013
w w hen
2.37
Advertisement
Table of Contents
