Power Heat Duct (Optional) - Installation; Power Heat Duct - FireplaceXtrordinair 864 TV 40K Installation Manual

Optional Equipment

Power Heat Duct (Optional) - Installation

Cover plates on top of the fireplace allow a Power Heat Duct kit to be installed on this fireplace. See the instructions
below for details.

Power Heat Duct

DO NOT remove the two knockouts on the left side of the fireplace.
These knockouts are used for the CoolSmart TV installation ONLY.
Remove the 2 pairs of cover plates below the top cover plate (2 screws hold each plate in place). DISCARD THE
4 COVER PLATES. Once all of the cover plates are removed the fireplace should look like the illistration below to
the right.

Re-install the top cover plate (with 6" knock out) and secure it with the screws removed earlier.

Use snips to cut the tab on the knockout located on the top
cover plate. Press on the far side of the tab to pop the edge
of the knockout up. Grab on to the knockout with pliers and
bend it back and forth until the remaining tabs break free.
Discard the knockout. The flexible duct will attach to this
location (see picture below and instructions included with
the power heat duct).
© Travis Industries
Remove this top cover plate
Remove these 4 cover plates
(for qualified installers only)
4/23/2021 - 1480
59
864 40K Install