Vent Configuration - Horizontal Termination - FireplaceXtrordinair 864 TV 40K Installation Manual

26 Finalizing the Installation

Vent Configuration - Horizontal Termination


The termination must fall within the shaded area shown in the chart. Use the indicated restrictor and
diffuser positions.

Up to four elbows (30°, 45°, 60° or 90°) may be used.

Use 8" (203mm) diameter vent (see page for 21 details).

Only one horizontal elbow may be used.

NG Installations require 1' Vertical Vent Section Directly off Top of Fireplace

LP Installations require 2' Vertical Vent Section Directly off Top of Fireplace
NOTE: If removing the restrictor, make sure to replace the screws in the firebox ceiling.
This is considered a
horizontal elbow (it doesn't
matter whether it turns right
or left). It may be a 30°, 45°,
60°, or 90° elbow.
© Travis Industries
(for qualified installers only)
H2
Horizontal length is calculated by
adding both lengths of horizontal run
(Horizontal Length = H1 + H2).
This is
H1
considered a
vertical elbow.
4/23/2021 - 1480 864 40K Install