Adjusting The Blower Speed; Optional Power Heat Duct Operation; Normal Operating Sounds - FireplaceXtrordinair 44 DV XXL Owner's Manual

Adjusting the Blower Speed

The internal blower helps transfer
the heat from the fireplace into the
room. It will not turn on until the
fireplace is up to temperature
(approximately 10 minutes after
starting). See the illustration below
for instructions on adjusting the
blower speed.
Optional Power Heat Duct
Allow the fireplace to reach normal operating temperature. Then use the wall-mounted rheostat to
operate the blower speed. The blower will automatically shut off after the fireplace cools.
Turn the dial all
the way counter-
clockwise until it
clicks off.

Normal Operating Sounds

Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve is turned on
and off you will hear a dull clicking
sound. This is the valve opening up
and shutting down.
Travis Industries
Operation
OFF
LO
BLOWER
CONTROL
OFF HIGH
The high position is
all the way counter-
clockwise, without
clicking off.
9 3 5 0 8 1 0 9
Blower Knob
HI
Turn the knob all the way counter-clockwise to turn
the blower off. One click clockwise turns the
blower to high speed. Turning the knob clockwise
from the high position decreases the speed of the
blower.
LOW
Turn the dial
all the way
clockwise.
Blower
This heater uses two blowers to push
heated air into the room. You will hear
the sound of air movement that
increases as the speed is increased.
The appliance will
creak with change of
temperature.
Blower Snap Disk
This part can
produce a clicking
sound as it turns the
blower on and off.
1 8 0 5 0 1
3 9