Installation Warnings; Warnings For The User - GiBiDi BL240 Instructions For Installation Manual

BL240
INTRODUCTION
The BL240 operator for swing gates is an electromechanical device that transmits motion to the gate by means of a
worm screw. It is locked when the motor is not running, and it is therefore not necessary to install locks for leafs up to
2 m.

INSTALLATION WARNINGS

• Before proceeding with installation, fit a magnetothermal or differential switch with a maximum capacity of 10A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3 mm.
• Keep all the materials contained in the packaging away from children, since they pose a potential risk.
• The manufacturer declines all responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used.
• After installation, always carefully check proper functioning of the system and the devices used.
• This instruction manual addresses professionals qualified to install "live equipment" and therefore requires good
technical knowledge and installation in compliance with the regulations in force.
• Maintenance must be carried out by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This product has been designed and constructed exclusively for the use indicated in this documentation. Any
other use may cause damage to the product and be a source of danger.
• Check the intended end use and take all the necessary safety precautions.
• Use of the product for purposes different from the intended use has not been tested by the manufacturer,
therefore any work is carried out on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children or animals should not play or stand near the gate.
• Appropriately protect the danger points (for example, using a sensitive frame).
• Check proper installation of the earthing system. connect all the metal parts of doors, gates, etc. and all the
system components to an earth terminal.
• Exclusively use original spare parts for any maintenance or repair operations.
• Do not modify any components of the automated device unless expressly authorised by Gi.Bi.Di.
Use suitable cable clamps to ensure that the wiring is properly connected mechanically and such that an IP44
degree of protection is maintained.

WARNINGS FOR THE USER

In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service.
Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel using
original and certified materials.
The product may not be used by children or persons with reduced physical, sensorial or mental capacities, or lacking
experience and knowledge, unless appropriately instructed.
Do not access the circuit board for adjustments and/or maintenance.
CAUTION: IMPORTANT SAFETY INSTRUCTIONS.
It is important to follow these instructions in order to safeguard persons.
Keep this instruction booklet
15
UK