Launch Control - DT SWISS Forks ER Instruction Manual

4.2.2.4 REMOTE LOCKOUT
MANIPULATION
Push the remote lever to position 2 to activate the rebound lockout. Pull the remote lever back to position 1 to deactivate it.
Push the lever to position 3 to activate the compression lockout. Pull the remote lever back to position 1 to deactivate it. When
you deactivate the compression lockout, the remote lever springs automatically back to position 1.
ADJUSTMENT
• Deactivate the lockout function by pulling the remote lever to position 1. The cable of the remote lockout is loose.
• Screw the adjustment screw of the pipe until block
• Unscrew the adjustment screw step by step to adjust the tension of the cable
• Control the lockout function by pushing the remote lever from position 1 into position 2. The adjustment is correct once the
fork cannot be compressed anymore.
Pos 1
Lockout open

4.2.3 LAUNCH CONTROL

INFORMATION
Through horizontal or upside-down storage of the fork, air gets into the damping oil chamber. The damping as well as the
Launch Control function does not work correctly. By compressing the fork repeatedly in upright position, the oil chamber gets
bled and the damping as well as the Launch Control function will work correctly.
4.2.3.1 ADJUSTMENT OF THE REBOUND DAMPING
You can turn the red wheel on top of the right stanchion to adjust the rebound damping. Clockwise to get it slower, counter-
clockwise to get it faster.
4.2.3.2 ADJUSTMENT OF THE COMPRESSION DAMPING
To adjust the low speed compression, turn the blue adjuster knob at the bottom end of the right stanchion. The turning-direc-
tion is shown on the dropout by +/– symbols.
+ Increase of the low speed compression, the fork gets harder
– Decrease of the low speed compression, the fork gets softer
Pos 2
Rebound Lockout activated
(only Twin Shot)
Pos 3
Compression Lockout
activated
17