SMC Networks SI Unit Operation Manual page 44

Device type/equipment identification
Version: HW/FW
Creator
Remark
No.
Have all the mandatory requirements for the "Planning" checklist
1
been met?
Have all the mandatory requirements for the "Assembly and
2
electrical installation" checklist been met?
Have all the mandatory requirements for the "Commissioning and
3
parameterization" checklist been met?
Does the parameterization of the safe outputs correspond to the
4
version and the actual connection of the controlled device?
Has the assignment of the valves to the outputs and the variables of
5 the safe application program been tested(online status in PROFIsafe
controller software)?
Has a function test been performed to check all safety functions, in
6
which the module is involved?
7 Have measures been taken to achieve a specific Cat.?
8 Do all cables correspond to the specifications?
Does the power supply correspond to the specifications for the
9 protective extra-low voltage (PELV) or safety extra-low voltage
(SELV)?
Have the voltage supply of PWR and PWR(V) from a power supply
10
unit been correctly implemented?
Is external protection of the module implemented (according to the
11 specifications in this user manual for supply voltage PWR and
PWR(V))?
12 Have measures been taken to prevent simple manipulation?
Are the requirements for the valves and cable installation observed
13
according to the SIL/SILCL/Cat./PL?
Are test intervals specified for testing the shutdown capability of the
14
actuators, if this is required to achieve a SIL/SILCL/Cat./PL?
Has it been ensured that any person intentionally starting hazardous
15
movements can only do so with a directly view of the danger zone?
Table C-5 Validation
Checklist for validation
Requirement (optional)
- 43 -
Date
Test engineer
Yes
Date
Date
Remark
Signature (creator)
Signature (test engineer)
No.EX※※-OMU1006-B