Advertisement
PackshotCreator R3 Mark II
HARDWARE INSTALLATION
ACRYLIC PANEL INSTALLATION 2/2:
07
Place the acrylic panel with
Note:
a small hole at bottom on the left
side when using a PackshotSpin
O3T inside the PackshotCreator, so
the power and USB cables can be
strung through the small hole and
then pluged into the power jack
and USB port on the frame of the
bottom light panel respectively.
10
Respectively insert the acrylic
panels between the metal guide
bracket on the top.
08
Reverse steps 01-04 to replace the
top and top light.
Align the acrylic panels
Note:
between the metal guide brackets
on the top, before tightening.
11
Finally slide the rest of the panel
into the guide notch on the back
wall holding bracket.
09
The acrylic panels can
(Optional):
also be installed through the front
when the front door is detached.
Insert the acrylic panels between
the guide notch on the bottom.
Advertisement
